Well done! when ever you want to code/write to the cars modules use this one. Password is repxet).Ħ) Make sure under button ‘Individualisierung’ all options are crossed.ħ) Make sure under button ‘FSW/PSW’, that ‘from CVT’ is chosen, and that the bottom two boxes are crossed.Ĩ) Finally, press ‘consistence check’ and check it works. zs30 Location Offline Senior Member Reputation: 114. Pass in PM after thanks and reputation+.tnx Thanks given by: Reply. Once you're there, select 'PROCESS ECU', select the correct module you are coding, in this case 'LSZ'. If anybody has this or can point me in the right direction Id much appreciate it. Open up NCS expert, load up 'revtors' profile (with manipulation enabled), and reload it to the part where the VO is loaded and its asking you to process ecu (Basically steps 1-3) Look above how to do this. I’m going to show you how to setup a “coding” profile this is key to getting the actual programming correct, the profile will allow you to have the right permissions to code the modules.ġ) Open NCS Expert (usually icon on your desktop)ģ) Save as a new profile (Call it “coding” or something similar. The folder contains also the Revtors NCS Expert profile. Hi all, Im looking for the Expert and Revtors profile for NCS Expert 4.01.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |